Dell PowerEdge 700 Installation And Troubleshooting Manual page 56

Error message indicates a processor problem.
l
A heat sink is not installed for the processor.
l
Action
CAUTION: See your System Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.
1. Ensure that you are running the latest BIOS version.
You can download the latest BIOS version from the Dell Support website at support.dell.com.
2. Run the appropriate online diagnostics test. See
3. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
4. Remove the bezel. See "Removing the
5. Lay the system on its right side.
6. Remove the cover. See "Removing the
7. Remove the cooling shroud. See
8. Ensure that the processor and heat sink are properly installed. See
9. Install the cooling shroud. See
10. Install the cover. See "Replacing the
11. Stand the system upright.
12. Install the bezel. See "Installing the
13. Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
14. Run Quick Tests in the system diagnostics. See
If the tests fail or the problem persists, see
Back to Contents Page
"Using Server Administrator
Bezel."
Cover."
"Removing the Cooling Shroud" in "Installing System Options."
"Installing the Cooling Shroud" in "Installing System Options."
Cover."
Bezel."
"Running System
"Getting Help."
Diagnostics" in "Running System Diagnostics."
"Replacing the Processor" in "Installing System Options."
Diagnostics."