Advertisement
Chapter 1
General Troubleshooting
Figure 1-56
Plug
Slide the GBIC through the flap that covers the opening until you hear a click. The click indicates the
Step 5
GBIC is locked into the slot.
Step 6
When you are ready to attach the network fiber-optic cable, remove the protective plug from the GBIC
and save the plug for future use.
Install a GBIC with a Handle
Remove the GBIC from its protective packaging.
Step 1
Check the label to verify that the GBIC is the correct type (SX, LX, or ZX) for your network.
Step 2
Step 3
Verify that you are installing compatible GBICs; for example, SX to SX, LX to LX, or ZX to ZX.
Step 4
Remove the protective plug from the SC-type connector.
Step 5
Grip the sides of the GBIC with your thumb and forefinger and insert the GBIC into the slot on the
E1000-2-G or G-Series card.
Note
Step 6
Lock the GBIC into place by closing the handle down. The handle is in the correct closed position when
it does not obstruct access to SC-type connector.
1.12.3 Optical Card Transmit and Receive Levels
Each STM-N card has a transmit and receive connector on its faceplate. The transmit and receive levels
for each card are listed in
July 2005
GBIC Installation With Clips
E1000
2
FAIL
ACT
SF
RX
1
TX
ACT/LINK
ACT/LINK
RX
2
TX
GBICs are keyed to prevent incorrect installation.
Table
1-7.
1.12.3 Optical Card Transmit and Receive Levels
Cisco ONS 15454 SDH Troubleshooting Guide, R5.0
1-143
Advertisement
