Advertisement
1.11.9 Circuits Remain in PARTIAL Status
1.11.9 Circuits Remain in PARTIAL Status
Symptom
1.11.9.1 Repair Circuits
In node view, click the Circuits tab. Note that all circuits listed are PARTIAL.
Step 1
In node view, choose Repair Circuits from the Tools drop-down list. The Circuit Repair dialog box
Step 2
appears.
Read the instructions in the Circuit Repair dialog box. If all the steps in the dialog box have been
Step 3
completed, click Next. Ensure that you have the old and new MAC addresses.
Step 4
The Node MAC Addresses dialog box appears:
a.
b.
c.
The Repair Circuits dialog box appears. Read the information in the dialog box and click Finish.
Step 5
Note
When the circuit repair is complete, the Circuits Repaired dialog box appears.
Click OK.
Step 6
In the node view of the new node, click the Circuits tab. Note that all circuits listed are DISCOVERED.
Step 7
If all circuits listed do not have a DISCOVERED status, call the Cisco TAC (1-800-553-2447) to open a
Return Material Authorization (RMA).
1.12 Fiber and Cabling
This section explains problems typically caused by cabling connectivity errors. It also includes
instructions for crimping CAT-5 cable and lists the optical fiber connectivity levels.
Cisco ONS 15454 SDH Troubleshooting Guide, R5.0
1-136
Circuits remain in the PARTIAL status.
The MAC address changed.
Possible Cause
Repair the circuits. See the
Recommended Action
page
1-136.
From the Node drop-down list, choose the name of the node where you replaced the AIE.
In the Old MAC Address field, enter the old MAC address.
Click Next.
The CTC session freezes until all circuits are repaired. Circuit repair can take up to five minutes
or more depending on the number of circuits provisioned.
Chapter 1
"1.11.9.1 Repair Circuits" procedure on
General Troubleshooting
July 2005
Advertisement
