Advertisement
Chapter 1
General Troubleshooting
Verify General Card LED Operation
In node view, click the Maintenance > Diagnostic tab
Step 1
Figure 1-46
Click Lamp Test.
Step 2
Watch to make sure all the port LEDs illuminate simultaneously for several seconds.
Step 3
Click OK in the Lamp Test Run dialog box.
Step 4
With the exceptions previously described, if an STM-N or electrical LED does not light up, the LED is
faulty. Return the defective card to Cisco through the RMA process. Log into the Cisco Technical
Support Website at http://www.cisco.com/techsupport for more information or log into
http://www.cisco.com/warp/public/687/Directory/DirTAC.shtml to obtain a directory of toll-free Cisco
TAC numbers for your country.
Verify G-Series Ethernet or FC_MR-4 Card LED Operation
G-Series and FC_MR-4 card-level LEDs illuminate during a lamp test, but the port-level LEDs do not.
Note
July 2005
CTC Node View Diagnostic Window
(Figure
1-46).
Cisco ONS 15454 SDH Troubleshooting Guide, R5.0
1.7.1 Card LED Lamp Tests
1-105
Advertisement
