Advertisement
Chapter 1
General Troubleshooting
Before continuing with the next step, verify that the database to upload is correct. You cannot reverse
Caution
the upload process after you click Yes.
Review the information on the Confirm NE Re-Initialization dialog box, then click Yes to start the
Step 6
reinitialization.
The reinitialization begins. After the software is downloaded and activated and the database is uploaded
to the TCC2/TCC2P cards, "Complete" appears in the status bar and the TCC2/TCC2P cards will reboot.
Wait a few minutes for the reboot to complete.
After the reboot is complete, log into the node.
Step 7
Manually set the node name and network configuration to site-specific values. Refer to the
Step 8
Cisco ONS 15454 SDH Procedure Guide Chapter 10, "Change Node Settings," for information on
setting the node name, IP address, mask and gateway, and IIOP port.
1.9 PC Connectivity Troubleshooting
This section contains information about system minimum requirements, supported platforms, browsers,
and Java runtime environments (JREs) for Release 5.0, and troubleshooting procedures for PC and
network connectivity to the ONS 15454 SDH.
1.9.1 PC System Minimum Requirements
Workstations running CTC release 5.0 for the ONS products on Windows platforms need to have the
following minimum requirements:
•
•
•
•
•
1.9.2 Sun System Minimum Requirements
Workstations running CTC release 5.0 for the ONS products on Sun workstations need to have the
following minimum requirements:
•
•
•
1.9.3 Supported Platforms, Browsers, and JREs
Release 5.0 CTC supports the following platforms:
July 2005
Pentium III or higher processor
Processor speed of at least 700 MHz
256 Mb or more of RAM
50 Mb or more of available hard disk space
20 GB or larger hard drive
UltraSPARC or faster processor
256 Mb or more of RAM
50 Mb or more of available hard disk space
1.9 PC Connectivity Troubleshooting
Cisco ONS 15454 SDH Troubleshooting Guide, R5.0
1-113
Advertisement
