Install Software Updates With Autoinstall; Optional Microsd Card Method - Honeywell ScanPal EDA51 Series User Manual

Install Software Updates with AutoInstall

Important: The EDA51 must have power for the entire length of the upgrade process or it could
become unstable. Do not attempt to remove the battery during the process.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings
3. Tap the toggle button to turn Provisioning mode On.
4. Save the upgrade file (*.zip or *.apk) in one of the following folders on the
5. Swipe up from the bottom of the Home screen to access all apps.
6. Tap AutoInstall Settings
7. Tap Packages Update from the AutoInstall Settings screen.
8. Once installation is complete, turn Provisioning mode Off.
Note: Some updates do not require the computer to restart before installation.

Optional microSD Card Method

The EDA51 comes equipped with a microSD card socket. You can install an
upgrade from a microSD card you insert in the computer.
Important: The EDA51 must have power for the entire length of the upgrade process or it could
become unstable. Do not attempt to remove the battery during the process.
1. On the EDA51, swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings
3. Tap the toggle button to turn Provisioning mode On.
4. Tap AutoInstall Settings
5. Press and hold the Power button, and then tap Power off.
72
> Provisioning mode under Honeywell Settings.
EDA51 mobile computer:
• Internal shared storage\honeywell\autoinstall
Software upgrades saved to this folder for installation, do not persist when a
Full factory reset or Enterprise data reset is performed.
IPSM card\honeywell\autoinstall
•
Software upgrades saved to this folder, do not persist when a Full factory
reset is performed. However, the upgrade does persist if an Enterprise data
reset is performed.
If required by the app, the computer may automatically initiate a reboot before
starting the installation process. When the installation is finished, a message
appears or the unit finishes rebooting and the lock screen appears.
> Provisioning mode under Honeywell Settings.
and verify Autoinstall is enabled
. Verify AutoInstall is enabled
.
.
EDA51 User Guide