Battery Part Numbers; Charge The Battery Before Use - Honeywell ScanPal EDA51 Series User Manual

Contact your local sales representative for replacement battery ordering
information.
Caution: Improper battery replacement or incompatible device usage

Battery Part Numbers

Model Number
EDA51-0
EDA51-1
Configuration number (CN) is located on the label in the battery well of the mobile computer.
Caution: Read

Charge the Battery Before Use

ScanPal EDA51 computers ship with the battery significantly discharged of power.
Fully charge the battery before using your computer for the first time.
You can charge the battery with a ScanPal EDA51 series charging accessory before
or after you install the battery in the computer. A fully discharged battery charges
in approximately 4.5 hours.
To charge the battery before you install it in the computer:
•
To charge the battery after installing it in the computer:
•
Note: Using the computer while charging the battery increases the time required to reach
a full charge.
EDA51 User Guide
may result in risk of burns, fire, explosion, or other hazard.
Dispose of lithium-ion batteries according to local regulations.
Risk of fire and burns if improperly handled. Do not open, crush,
heat above 60°C (140°F), or incinerate.
Battery Part Number
50129589-001, 50134176-001
50129589-001, 50134176-001
Battery Recommendations and Safety Protections
page 11 and all cautionary markings on the battery, charging
peripheral, and device using the battery before attempting to
install, use, or charge the battery.
Insert the battery into the EDA51 Quad Battery Charger or the battery well of a
EDA51 Standard Home Base or Ethernet Home Base connected to a power
source.
Insert the computer into a EDA51 Standard Home Base, Ethernet Home Base,
Charge Base, Net Base, or Snap-On USB Adapter connected to a power source.
on
5