Add A Scan Setting Profile - Honeywell ScanPal EDA51 Series User Manual

Trigger Settings
Setting
Enable Scan
Trigger
Scan delay
Decode Timeout
Trigger Scan
Mode
Same symbol
timeout
Notification Settings
Use the Notification Settings to configure how your computer responds when you
scan a bar code.
Notification Settings
Setting
Good Read Notification
Bad Read Notification
Vibrate On Notification

Add a Scan Setting Profile

To create a scan setting profile for a custom app on the computer:
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings
3. Tap
EDA51 User Guide
Description
Enable or Disable activating the imager by pressing the side scan
buttons or the virtual Scan button in the Scan Demo app.
Set the minimum amount of time in seconds before the scanner
can read another bar code.
Set the number of seconds before the scanner automatically turns
off if the scan button is pressed and nothing has successfully
decoded.
Set read behavior on scan button press. Options available:
• One Shot
• Continuous
• Read on release
• Read on second trigger press
Set the minimum buffer time in seconds before the scanner reads
the same bar code. This can be adjusted to prevent inadvertent
scans of the same bar code if the code is left in the scan field
longer than the Decode Timeout limit. The default same symbol
timeout is 1000 seconds.
Description
Enables or disables a good read notification. The
notification consists of a green blink of the Scan Status
LED, a short beep, and an optional short vibration.
Enables or disables notification of a failed scan. The
notification consists of a red blink of the Scan Status LED,
an error beep, and an optional short vibration.
Enables or disables whether the computer vibrates when
there is a good or bad read.
> Honeywell Settings > Scan Settings > Internal Scanner.
in the upper right corner of the app screen.
Default
Enabled
0
20
One
Shot
Disabled
Default
Enabled
Disabled
Disabled
37