Connect To Mobile Network; Connect To A Wi-Fi Network - Honeywell ScanPal EDA51 Series User Manual

•
•
•
•

Connect to Mobile network

Mobile network only supported on EDA51-1 WWAN version. Before using mobile
network, need to insert activated local carrier's Nano SIM card.
1. Enter Settings > Mobile network > Mobile Data.
2. Tap Mobile Data to on (Default status is on).
3. Using the mobile computer transfer data through local carrier's network.

Connect to a Wi-Fi Network

The computer contains an 802.11 a/b/g/n/ac radio to transfer data using WWAN
communications. Before you connect to a Wi-Fi network, you need to know about
your network security protocol and its required credentials.
By default, the 802.11 radio is disabled.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings
3. Tap Off
4. On the list, tap a network name to initiate a connection.
5. Enter any required information if the network is secured (e.g., password, key or
6. Tap Connect.
Once you connect to a saved Wi-Fi network:
•
•
EDA51 User Guide
Mobile network
802.11 a/b/g/n/ac radio communications
Bluetooth communications
USB and serial communications
> Network & Internet > Wi-Fi.
to toggle Wi-Fi radio On
To add a network if it does not appear on the list:
a. Navigate to the end of the discovered network list, and then tap
Add network.
b. Type the Wi-Fi network name (SSID).
c. Choose a security protocol and add any required information.
d. Tap Save.
certificate name).
Tap the network name on the list to view details (e.g., status, signal strength,
speed, frequency, security type). Select Cancel to close details screen.
The computer automatically connects to the same network when the network is
in range and the WLAN radio is turned On.
. A list of discovered networks appears.
59