AMQ ILINE Series Installation Manual page 38

PHASE 2 | Beam Assembly (4-Circuit)
Step 3
Mount 2 receptacle on one side of the junction block. Insert the junction block slighfly tilted like in the
diagram with the junction block without the receptacles facing the beam cut-out.
Step 4
Clip on the receptacles to the junction block
through the beam cut-out.
Step 6
Place the face plate cover over the beam cut-
out. Position it like in the diagram.
wide
narrow
ILINE INSTALLATION GUIDE | 38
Beam Cut-Out Side
Step 5
Take 3 junction block (4-circuit) and position it as
shown in the diagram. Push it down until it can go
no further.
Step 7
Slide-in the sliding clip till the tab locks into the
face plate.
ILINE 90°/180° (4-WAY)
amqsolutions.com