PHASE 2 | Beam Assembly (3-Circuit)
Step 3
Mount 2 receptacle on one side of the junction block. Insert the junction block slighfly tilted like in the
diagram with the junction block without the receptacles facing the beam cut-out.
Step 4
Clip on the receptacles to the junction block
through the beam cut-out.
Step 6
Place the face plate cover over the beam cut-
out. Position it like in the diagram.
wide
narrow
ILINE INSTALLATION GUIDE | 20
Step 5
Take 2 junction bracket (3-circuit) and position
them as shown in the diagram below. Make sure
the base of the bracket is touching the beam. Now
take the 4 self-tapping screws which are supplied
with the bracket and screw them in.
Step 7
Slide-in the sliding clip till the tab locks into the
face plate cover.
ILINE 120° (3-WAY)
Beam Cut-Out Side
amqsolutions.com