Lifting Procedure - Terex TSV-70 Operation And Maintenance Manual

6 TRANSPORTATION

6.4 Lifting Procedure

Lifting the machine should only be done from beneath the machine with a jack of
the proper capacity.
To safely lift your machine:
1. Remove any attachments that may be fastened to the machine and raise
the lift arms.
2. Install the lift arm brace as instructed in section 5.14.
3. Once the lift arms are secured, carefully exit the machine.
4. Roll or slide your jack under the front of the machine and center the lifting
pad (left to right) on the flat bottom surface of the chassis.
5. Once in place, jack/lift the machine upward making sure it remains stable
until it has reached sufficient height to install suitable mechanical supports
beneath the machine.
6. Slide the mechanical supports into place making sure to position them in a
manner that will allow the machine to remain stable when the jack is
lowered and the front of the machine rests on the supports.
7. Once the supports are in place, slowly lower the machine onto them, then
remove the jack.
Repeat steps 4-7 at the rear of the machine should both ends of the machine
need to be off of the ground for service.
Lift the machine straight up in a slow and careful manner. Lower it this same way
making sure all persons in the area are clear of the machine and its expected
path.
When lifting attachments or components, use caution. Attach straps or
chains securely and in such a way that they evenly distribute the weight
of the item to be lifted, ensuring a balanced load. Stay clear of expected travel
path.
62