Chassis; Removing Driver's Seat; Changing Throttle Cable - Husqvarna P 520D Workshop Manual

Chassis

CHASSIS

Removing Driver's Seat

WARNING!
The seat is heavy and can fall if let
go. Secure it from falling. Risk of
personal injury.
Tools Dimension
Combination 13 mm
wrench
Socket wrench 13 mm
Wire cutters
1. Tilt the seat back.
2. Cut the cable ties and loosen the connection (1).
3. Secure the seat from falling back when the stay
(2) and hinge (4) are loosened.
4. Unhook the stay (2) from the frame recess first,
then from the seat.
5. Loosen the two hinges (4) and lift away
the seat.
6. Reassemble the seat in the reverse order.
7. Check the safety breaker after assembly.
See the Operator's Manual.
1
2
3
4
1. Connection with cable ties
2. Stay
3. Notch
8
– English
Repair Instructions
Quantity
1
1
1
5
4. Hinge
5. Lock mechanism

Changing Throttle Cable

Tools Dimension
Socket wrench 10 mm
Combination 13 mm
wrench
Torx
Snipe nose pliers
1. Pull back on the throttle control (1) to its end
position.
2. Remove the side cover.
3. Open the engine cover.
4. Loosen one or both lock nuts (6) on the throttle
cable fastening on the engine control arm.
Remove the air cleaner if necessary to make
room.
5. Pull the throttle cable (4) through to the right
side. Note the route of the cable through the
machine.
6. Press the throttle cable (4) out of the cable
holder (5).
7. If it is difficult to access, loosen the throttle
control. First remove the plastic knob on the
control bracket. Then unscrew the bracket.
1
2
6
7
1. Throttle control
2. Control bracket
3. Screw
4. Throttle control cable
8. Assemble in the reverse order.
9. Check the operation of the throttle control. See
Checking the Engine Speed.
Quantity
1
1
T30 1
1
5
4
3
5. Cable holder
6. Lock nuts
7. Control arm