Husqvarna P 520D Workshop Manual page 13

Chassis
9. Remove five screws (1) so that the base plate
(2) can be loosened from the front edge.
1. Screw
2. Base plate
10. Remove five screws (1) so that the front edge of
the base plate (2) can be loosened.
1. Reverse pedal
2. Pedal cable
3. Clevis pin
12
– English
1
2
1
2
3 4 5
4. Split pin
5. Torsion spring
11. Press out the pedal shaft (9) and dismantle one
pedal arm at a time. Lift up the base plate to
allow the reverse pedal to pass.
1 2 3
1. Link arm
2. Rubber seal
3. Profile washer
4. Nut
5. Return spring
6. Split pin
12. Pull the bushings (1) out of the pedal arms.
13. Fit new bushings.
1
1. Bushing
2. Forward pedal
3. Reverse pedal
IMPORTANT!
It is a good idea to fit the cable before the link
arm is refitted.
14. Refit the pedal bracket in the reverse order.
15. Lubricate the bushings through the grease
nipples.
12
11
10
9
5
8
4
6 7
7. Clevis pin
8. Forward pedal
9. Pedal shaft
10. Retaining ring
11. Washer
12. Pedal cable
2
3
1 1
1