5.
Unscrew the two screws holding the headlamp
insert (2). Do not misplace the two loose clip
nuts on the lamp insert console.
6.
Lift out the headlamp insert.
1
1.
Headlamp insert
7.
Dismantle the headlamp console (6).
8.
Loosen all electrical connections.
9.
Dismantle the ignition switch (2).
10. Dismantle the cover (5).
11. Place a container under the steering servo
to collect the spill oil.
12. Clean according to the general instructions,
see Hydraulic System.
13. Mark up how the hydraulic lines are connected.
14. Loosen the hydraulic lines from the steering
servo (1). Fit protective plugs.
3
2
1
1.
Screw
1.
Ignition switch
2.
Light switch connection
3.
Warning lamp connections
4.
Cover
2
2.
Cover
4
5
6
7
8
9
9
5.
Headlamp console
6.
Temperature gage
connection
7.
Clip nut
8.
Console retaining screw
IMPORTANT!
Make sure the O-rings remain mounted in the
adapter on the steering servo.
IMPORTANT!
Connections can be interchanged. Mark the
hydraulic hoses so that they are reassembled
on the correct connections. NB! The
connections on the steering servo are marked
with letters.
Hydraulic System
57
English –