Changing Pedal Bracket Bushings - Husqvarna P 520D Workshop Manual

Changing Pedal Bracket Bushings

Tools Dimension
Groove joint
pliers
Combination 13 mm
wrench
Combination 15 mm
wrench
Socket wrench 13 mm
Screw driver 5 mm
1. Start the machine and raise the lift arms.
2. The lift arms can fly up if the lever for the
hydraulic lift is unintentionally operated. Prevent
this by pulling out the retainer spring (6) and
removing the clevis pin (7) for the auxiliary lift
spring (8).
1 2
5
6
1. Reverse pedal
2. Forward pedal
3. Half speed catch.
4. Link arm
Quantity
1
1
1
1
1
3
4
8
7
5. Cable
6. Retainer spring
7. Clevis pin
8. Auxiliary lift spring
3. Lower the lifting arms.
4. Turn off the machine and make sure it can not
be restarted.
5. Dismantle the pedal cable (2) split pin (4) and
clevis pin (3).
1. Reverse pedal
2. Pedal cable
3. Clevis pin
6. Dismantle the pedal cable (12) by removing
the split pin (6) and the clevis pin (7).
7. Loosen the link arm (1) by removing the nut (4).
Hold the profile washer (3) with a 13 mm
combination wrench so the bolt does not turn.
Take care not to damage the rubber seal on the
link arm.
8. Dismantle the retaining ring (10) and one
washer (11).
1 2 3
1. Link arm
2. Rubber seal
3. Profile washer
4. Nut
5. Recoil spring
6. Split pin
Chassis
1
2
3 4 5
4. Split pin
5. Torsion spring
12
11
10
9
5
8
4
6 7
7. Clevis pin
8. Forward pedal
9. Pedal shaft
10. Retaining ring
11. Washer
12. Pedal cable
English –
11