To Remove And Install The Upper Chassis - Husqvarna Automower 405X Workshop Manual

6.5 To remove and install the upper chassis

1. Remove the top cover. Refer to
install the top cover on page 19 .
2. Remove the body. Refer to
the body on page 19 .
3. Remove the 12 screws.
4. Remove the warranty seal at the point of separation
between the chassis halves on the right side.
5. Lift the front end of the upper chassis.
20 - Repair instructions
To remove and
To remove and install
6. Disconnect the power cable (A) from the motor
control circuit board.
CAUTION: Always disconnect the power
cable first to prevent current spikes that may
harm the circuit boards or the battery.
7. Disconnect the application circuit board cable (B)
from the motor control circuit board.
8. Remove the upper chassis.
9. Install in opposite sequence.
10. When you connect the cables make sure to put the
cables in the cable holders. To put the cables into
position in the lower chassis:
B
A
1582 - 001 - 23.12.2020