Mounting The Linear Steering Position Sensor (Sps) - Raven SmarTrax Installation Manual

MOUNTING THE LINEAR STEERING POSITION SENSOR (SPS)

Mount SPS to either the left or right steering cylinder on the machine using the supplied brackets.
Remove the bolts holding the steering cylinder. Place bracket on mount and insert bolt through
bracket and tighten as shown in pictures.
Tighten SPS mounting screws in the outside hole in the mounting bracket. (i.e. the rear hole on the
rear bracket and the front hole on the front bracket)
Be sure not to over-compress or over-extend the SPS upon initial start-up. An additional hole may be
drilled in the bracket if sensor doesn't fit properly.
4