Performing Soft System Resets (Resets 4 And 5); Troubleshooting; Configuration Worksheets - Extron electronics DTP CrossPoint 84 User Manual

Performing Soft System Resets (Resets 4 and 5)

Perform a soft reset of the switcher as follows:
1.
2.

Troubleshooting

This section recommends what to do if you have problems operating the switcher.
1.
2.
3.
4.
5.
6.

Configuration Worksheets

Rather than trying to remember the configuration for each preset, use worksheets to record
this information. Make copies of the blank worksheet on
preset configuration. Cross out all unused or inactive inputs and outputs. Use different
colors for video and audio.
NOTE: All of the equipment in the following examples is connected through the
Use a small screwdriver to press and hold the rear panel Reset button until the Reset
LED and the front panel Video and Audio buttons blink the number of times for the
desired reset: twice (IP settings reset) or three times (absolute reset) (see figure 28).
Press and hold
Reset LED blinks twice.
the Reset button.
RESET
6 seconds
IP Settings
Reset
(Mode 4)
Front panel I/O buttons blink twice.
Press and hold
the Reset button.
RESET
9 seconds
Absolute Reset
(Mode 5)
Front panel I/O buttons blink three times.
Figure 28. Soft System Resets
Release the RESET button and then immediately press and release the Reset button
again. Nothing happens if the second momentary press does not occur within 1 second.
Ensure that all devices are plugged in and powered on.
Check to see if one or more outputs are muted.
Ensure an active input is selected for output on the switcher.
Ensure that the proper signal format is supplied.
Check the cabling and make corrections as necessary.
Call the Extron S3 Sales and Technical Support Hotline if necessary. See
www.extron.com
for the phone number in your region of the world.
appropriate transmitter or receiver.
DTP CrossPoint 84 Series Matrix Switchers • Operation
Release, then immediately
press and release again.
RESET RESET
I/O
VIDEO AUDIO
Reset LED blinks
Release, then immediately
three times.
press and release again.
RESET RESET
I/O
VIDEO AUDIO
page 51 and use one for each
47