Table of Contents
Advertisement
Switcher-initiated Messages
When a local event such as a front panel operation occurs, the switcher responds
by sending a message to the host. The switcher-initiated messages are listed below
(underlined).
The switcher does not expect a response from the host, but, for example, the host program
might request a new status.
(c) Copyright 20yy, Extron Electronics DTPCP84, Vx.xx, 60-nnnn-nn
{day, date, time}
The switcher initiates the
powered up and on a newly connected Internet protocol (IP) port.
version number and
Password:
The switcher initiates the
the controlling system is connected using TCP/IP or Telnet and the switcher is password
protected. This message means that the switcher requires an administrator or user level
password before it will perform the commands entered via this link. The switcher repeats
the password message response for every entry other than a valid password until a valid
password is entered.
NOTE: The factory configured passwords for all accounts on this device have been
]
]
The switcher initiates the
has been entered. If the user and administrator passwords are the same, the switcher
defaults to administrator privileges.
Qik
The switcher initiates the
Rprnn
The switcher initiates the
front panel. "
Amtnn*x
The switcher initiates the
the front panel.
GrpmDn*y
The switcher initiates the
the control:
Exen
The switcher initiates the
mode) is toggled on or off from the front panel. "
]
Copyright
60-nnnn-nn
]
Password
set to the device serial number. Passwords are case sensitive. If the device is
reset, the password will be the original password configuration.
Login Administrator
]
Login User
]
Login
]
message when a front panel tie creation has occurred.
Qik
]
message when a memory preset has been recalled from the
Rpr
" is the preset number.
nn
]
message when an output audio mute is toggled on or off from
Amt
is the output number and
nn
]
Grpm
(Mic Volume) or
1
]
message when the front panel security lockout (executive
Exe
DTP CrossPoint 84 Series Matrix Switchers • Programming Guide
message on the Remote RS-232 port when it is first
is the switcher part number.
message immediately after the copyright message when
message when a correct administrator or user password
is the mute status:
x
message when a front panel Volume knob is adjusted. "
(Volume)."
" is the variable.
2
y
" is the executive mode:
n
]
is the firmware
Vx.xx
= on,
= off.
1
0
" is
n
,
, or
.
0
1
2
54
Advertisement
Table of Contents
