Detailed Pin Assignments, Wiring, And Sample Applications - Extron electronics DTP CrossPoint 84 User Manual

Detailed Pin Assignments, Wiring, and Sample Applications

HDMI connectors
Figure 8 defines the pinout for the HDMI protocol.
Pin Signal
Pin Signal
1 TMDS data 2+
1 TMDS data 2+
2 TMDS data 2 shield
2 TMDS data 2
3 TMDS data 2-
4 TMDS data 1+
3 TMDS data 2-
5 TMDS data 1 shield
4
TMDS data 1+
6 TMDS data 1-
5 TMDS data 1
7 TMDS data 0+
6 TMDS data 1-
Figure 8.
Use the LockIt Lacing Brackets, supplied with the switcher, to securely fasten HDMI cables
to devices as follows (see figure 9):
1. Plug the HDMI cable into the panel connection.
3 3
1 1
Figure 9.
2.
Loosen the HDMI connection mounting screw from the panel enough to allow the
LockIt lacing bracket to be placed over it. The screw does not have to be removed.
3. Place the LockIt lacing bracket on the screw and against the HDMI connector, then
tighten the screw to secure the bracket.
ATTENTION:
•
•
4.
Loosely place the included tie wrap around the HDMI connector and the LockIt lacing
bracket as shown.
5. While holding the connector securely against the lacing bracket, use pliers or similar
tools to tighten the tie wrap, then remove any excess length.
19 1
18 2
HDMI
Type A Receptacle
Pin Signal
Pin Signal
8 TMDS data 0 shield
7 TMDS data 0+
9 TMDS data 0-
8 TMDS data 0
10 TMDS clock+
shield shield
11 TMDS clock shield
9 TMDS data 0-
12 TMDS clock-
10
TMDS clock+
13 CEC control
11 TMDS clock
shield shield
12 TMDS clock-
HDMI Connector
4 4
2 2
5 5
Installing the LockIt Lacing Bracket
Do not overtighten the HDMI connector mounting screw. The shield to which it
fastens is very thin and can easily be stripped.
Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel
elle est attachée est très fin et peut facilement être dénudé.
DTP CrossPoint 84 Series Matrix Switchers • Installation
1 19
2 18
HDMI
Type A Plug
Pin Signal
Pin Signal
14 Reserved (NC)
13 CEC control
15 SCL
14 Reserved
16 SDA
(NC)
17 DDC/CEC Ground
15 SCL
18 +5 V power
16
SDA
19 Hot plug detect
17 DDC / CEC
Ground
18 +5 V power
19 Hot plug detect
3
16