Table of Contents
Advertisement
Front Panel Security Lockouts
In the procedural descriptions that follow, it is assumed that the switcher is in Lock mode 0
(fully unlocked). The following two Lock modes are also available:
Lock mode 1 — All changes are locked from the front panel (except for setting Lock
•
mode 2). Some functions can be viewed.
Lock mode 2 — Advanced features are locked and can be viewed only. Basic functions
•
are unlocked.
NOTE: The switcher is shipped from the factory in Lock mode 2. See
Front Panel Locks (Executive Modes)
advanced functions and the procedure to set the various front panel locks.
Creating a Configuration
The current configuration can be changed using the front panel buttons. Change the current
configuration as follows:
Press the Esc button to clear any input button indicators, output button indicators, or
1.
control button indicators that may be lit.
2.
Press the Video button and Audio button as necessary to select video, audio, or both
for configuration.
3.
Select the desired input and one or more outputs by pressing the input and output
buttons.
Input buttons and output buttons light or blink:
•
•
•
•
To indicate potential ties, output buttons blink the appropriate color when an input
•
is selected.
To indicate current ties, output buttons light steadily the appropriate color when an
•
input is selected.
To clear unwanted outputs, press and release the associated lit output buttons.
•
To indicate potential unties, output buttons blink the appropriate color when an
output is deselected but not untied from the input.
4.
Press and release the Enter key to accept the tie or to break an existing tie.
5.
Repeat steps 1 through 4 to create or clear additional ties until the desired configuration
is complete.
NOTES:
•
•
•
•
•
Amber to indicate video and audio ties
Green to indicate video only ties
Red to indicate audio only ties
Only one video input and one audio input can be tied to an output.
If a tie is made between an input and an output, and the selected output was
previously tied to another input, the older tie is broken in favor of the newer tie.
If an input with no tie is selected, only the button for the selected input lights.
When the Video button and the Audio button are lit, if an input with an audio
tie but no video tie is selected, the button for the input and the button for the
output light the appropriate color (amber, green, or red).
As each input and output is selected, the associated output button blinks
the appropriate color to indicate a tentative tie. Buttons for outputs that were
already tied to the input light the appropriate color steadily. Outputs that are
already tied can be left on, along with new blinking selections, or toggled off by
pressing the associated output button.
DTP CrossPoint 84 Series Matrix Switchers • Operation
Setting the
on page 43 for a detailed list of basic and
29
Advertisement
Table of Contents
