Table of Contents
Advertisement
7.
If you want to tailor the push to the switcher (push just the configuration, just the
presets, or the configuration and selected presets), click the Advanced button (see
figure 60,
To push all of the DSP Configurator ties, gain and processor blocks, and presets to the
switcher, proceed to step 8.
a.
Select the Custom radio button (
b.
Select one or both check boxes as desired; Push Configuration and Push
Presets (
NOTE: Configuration includes all ties, mic mixes, and gain and processor
c.
If you selected Push Presets in step 7b, select either:
Selected (
All (
program is connected live to the switcher, completing the mode selection. Ties,
processors, and presets are pushed or pulled as selected.
d.
Select the desired presets to push by clicking the appropriate check boxes (
e.
Click OK (
8.
Click OK (
completing the mode selection. Ties, processors, and presets are pushed or pulled as
selected.
9.
If you have created ties or made any changes to the DSP parameters (including gain
and processor blocks) since the last time you saved to a file, the DSP Configurator
prompts you to save the file. Click Yes or No, as desired,
If a password was required and not entered or if an incorrect password was entered,
the program prompts for the password.
NOTE: The factory configured passwords for all accounts on this device have
been set to the device serial number. Passwords are case sensitive. If the
device is reset, the password will be the original password configuration.
DSP Configurator Windows Menus
DSP Configurator File menu
NOTE: New,
New — Discards the current DSP configuration (after prompting to save
any changes) and opens a blank configuration file with no inserted
processors, saved presets, created ties, or mic mixes.
Open — Loads and activates a previously saved DSP configuration file.
Save — Saves all changes to the current DSP configuration file under
the current file name. If the file has not previously been saved the program
prompts for a file name.
Save As — Saves all changes to the current DSP configuration file under a new file name.
Backup — Transfers all presets plus the current configuration to a DSP configuration file
within the DSP Configurator program.
Recent Files — Opens a list of recently opened or saved DSP configuration files, making
it easy to select one to open.
Exit — Closes the DSP Configurator Program.
on page 109) and proceed to step 7a.
3
).
5
blocks. This selection does not include presets.
) and OK (
)— The
6
8
and OK (
), equivalent to a standard push) — The DSP Configurator
7
8
). Proceed to step 9.
¢
). The DSP Configurator program is connected live to the switcher,
£
, and
Open
Recent Files
DTP CrossPoint 84 Series Matrix Switchers • Matrix Software
).
4
dialog box opens. Proceed to step 7d.
Select
are unavailable in Live mode.
).
9
110
Advertisement
Table of Contents
