Installing A Fire Cylinder - Huawei SmartLi 2.0 User Manual

SmartLi 2.0
User Manual
Context
● To prevent the SmartLi from falling over, secure it to a pallet truck using ropes
● To prevent shocks or falls, move the SmartLi gently. After placing the SmartLi in
● To prevent dust from settling on the SmartLi, leave the original plastic coat on
● Battery modules are transported separately.
Procedure
Step 1 Use a pallet truck to transport the SmartLi to the installation position.
Step 2 Remove the SmartLi outer packing and take out the fittings box.
Step 3 Check that the SmartLi is intact.
1.
2.
Step 4 After confirming that the cabinet is intact, remove the L-shaped bracket that
secures the cabinet and the pallet, and secure the sliding plate to the pallet using
the two M12 bolts that you have removed.
Step 5 Raise the four anchor bolts to the highest position using an adjustable wrench.
Step 6 Push the cabinet along the sliding plate to the floor.
----End

4.2 Installing a Fire Cylinder

Procedure
Step 1 Remove the rear panel of the cabinet.
Step 2 Observe the pressure gauge on the fire cylinder.
●
●
Step 3 Remove the dry contact cable from the fire cylinder.
Issue 03 (2020-08-07)
NO TICE
before moving it.
the installation position, unpack it and take care to prevent scratches. Keep the
SmartLi steady during unpacking.
until installation is required.
Visually inspect the SmartLi appearance for shipping damage. If it is
damaged, notify the carrier immediately.
Check that all fittings comply with the packing list. If some fittings are
missing or do not comply with the packing list, record this information and
contact your local Huawei office immediately.
If the pointer is in the green zone, the fire cylinder is filled with extinguishant.
Perform steps 10, 11, and 13.
If the pointer is in the red zone, the fire cylinder is empty. Perform steps 3–13
to fill extinguishant onsite.
Copyright © Huawei Technologies Co., Ltd.
4 Installation
35