Installing A Single Ups; Rack-Mounted Installation; Installing The Ups And Lead-Acid Batteries - Huawei UPS2000-H User Manual

UPS2000-H-(6 kVA-10 kVA)
User Manual
● Only trained personnel are allowed to move the equipment.
● Do not move the equipment by holding its mounting ears, front panel, wiring
● Move the chassis with caution. Any bumping or falling may damage the
Procedure
Step 1 Verify that the UPS packaging is intact. If any damage is found, notify the carrier
immediately.
Step 2 Move the equipment to the specified position.
Step 3 Remove the packing materials. Check whether the UPS exterior is in good
condition and free of collision marks or scratches. If any damage is found, notify
the carrier immediately.
Step 4 Check the type and quantity of fittings against the packing list. If some fittings are
missing or do not match the models in the packing list, record the information
and contact the supplier immediately.
----End

5.2 Installing a Single UPS

5.2.1 Rack-Mounted Installation

5.2.1.1 Installing the UPS and Lead-Acid Batteries

Procedure
Step 1 Install mounting ears on both sides of the UPS.
Figure 5-4 Installing UPS mounting ears
Issue 03 (2023-08-20)
NO TICE
terminal cover, or control panel.
equipment. After placing the equipment, unpack it carefully to prevent
scratches.
Copyright © Huawei Digital Power Technologies Co., Ltd.
5 Installation and Cable Connection
60