sauter KERN SW 1000 Instruction Manual page 33

4.4.7 RS-232 interface
Mode of the RS-232 interface:
RS-232 remote option, printer. Use the arrow keys <◄> , <►> to select. The
sound level meter can send and control data via the RS-232 port in remote mode.
The RS-232 port can be used to connect to a thermal printer (optional) in printer
mode.
ID setup:
In the ID setup (see
number to distinguish between several sound level meters in the network. You
can set the ID between 1 and 255. Press the arrow keys <◄>, <►> to select.
Baud rate:
The baud rate (for more details, see section
interface
4800 bps, 9600 bps, 19200 bps. Press the arrow keys <◄>, <►> to select.
The following options are supported:
Data flow control: (See
can set the data flow mode on remote control. The options are: Hardware,
Software. Press the arrow keys <◄>, <►> to select.
Answer:
Answer (see
disable the response signal (ACK/NAK). The options are: ON, OFF. Press the
arrow keys <◄>, <►> to select.
4.4.8 File Manager
SW-BA-e-2020
The RS-232 interface menu is used to set the options for the serial
connection, see 5.
5.2.2 Device ID for
settings) defines the speed for data exchange via the RS-232 interface:
5.2.7. Data flow
5.3 Instructions for
You can use the file manager to manage the saved SWN, OCT
and CSD file. The numeric display on the right side of each line is
the file counter for each file type. Use the arrow keys <▲> , <▼> to
select the option and press <Enter> to move to the next menu level
.
RS-232 data exchange
more information) you can set the ID
5.1 Hardware configuration and
control) With the data flow control you
further information). This allows you to enable or
In the SWN File menu, you can delete SWN files
using the arrow keys <▲>, <▼>. Select the file
number you want to delete. The complete file
name is displayed at the bottom of the screen.
Select 0000 for the file number if the entire
existing SWN file can be deleted.
protocol.
33