Table of Contents
Advertisement
1.8 Technical specifications (cont.)
Mechanical
mounting
connections
housing material
weight
front size
panel cut-out
depth from panel
Temperature
operation
storage
warm-up time
Functions included
'Fast access'
Manual offset
Thermocouple cold junction configurable
Sensor break detection
Display filters
Memory
Password
Alarms
Display brightness
'On Power Up'
Table 2 - Functions included
panel
plug-in screw terminal
ABS, polycarbonate (V0)
<150 grams
72 x 36 mm
69 x 32.5 mm
98 mm (including terminals)
from 0 to +50 ºC
from -20 to +70 ºC
15 minutes
yes
configurable
configurable
steps
max. and min. readings
configuration block
double setpoints
activation delays
deactivation delays
hysteresis
inverted relays
locked alarms
5 levels
yes
1.9 Messages and errors
The error messages are shown on display in flash mode.
Messages and errors
'h.oVr'
Hardware overrange ('h.ovr'). Input signal is higher than
the maximum signal the instrument can detect (80 mV)
'h.udr'
Hardware underrange ('h.udr'). Input signal is lower than
the minimum signal the instrument can detect (-30 mV).
'd.udr'
display underrange ('d.udr') / overrange ('d.ovr'). The
'd.oVr'
instrument already displays the minimum / maximum
value possible (-1999 / 9999).
'brk'
instrument will display 'brk' message in the following
cases
• when measuring Pt100 / RTD, the resistance measured
Section
is higher than 390 Ohms (higher than 850 ºC)
• when measuring Pt100 / RTD, the third wire (sense
1.11.5
wire) presents an impedance higher than 15 Ohms
1.11.2
• when measuring thermocouples, the thermocouple cir-
cuit is open circuit
1.11.2
'Err.1'
incorrect password.
1.11.2
'Err.2'
at 'oPt.X' menu entry. Installed module is not recognized.
Table 3 - Messages and error codes
1.11.4
1.11.4
1.11.9
1.11.3
1.11.12
1.11.7
FEMA ELECTRÓNICA . Series S . S40-T
5
Advertisement
Table of Contents
