Specification - Panasonic MINAS-BL KP Series Reference Specifications

4. Specification

4.1 General specification
Allowed range of supply voltage fluc-
tuation
Control method
Ambient temperature
Ambient humidity
Location
Altitude
Vibration
Storage temperature
Storage humidity
Number of positioning points
Positioning resolution
Input signal*3
Output signal*3
Communication
RS485
Communication
function via RS232C
Digital Keypad(sold separately) Available
Regenerative Break
Protective function
Speed control range
Overload rating
Permissible length for
motor cable
Permissible length for
control cable
Cooling system
Mass (kg)
*1 Please note that dew condensation easily occurs when the temperature decreases.
*2 It is the maximum length in our evaluation environment and it does not guarantee the operation in the
customer's use environment.
*3 The function of signal can be changed by Digital key pad, "Panaterm for BL" or RS485 communication.
*4 It is the range that can control the speed, and the rotation quality such as smoothness is affected by the
load condition and gain setting.
*5 Ambient temperature is measured at a distance of 50 mm from the product.
*6 External regenerative resistor: DV0P2890/DV0PM20068(100 V/200 V)
＊ Take the signal input (I1, I2 and so on) for Start and Stop basically. The power ON and OFF may cause
short lifetime in the internal circuit.
* Trip means that a protection circuit operates and stops.
Speed control by CS signal, PWM sine wave driving system
20～85 % RH or below (free from condensation)
Indoor（No corrosive gas, A place without garbage, and dust）
-20 ℃~65 ℃
(max temperature 80 ℃72 hr, Free from freezing)*1
20～85 % RH or below (free from condensation)
4 points(Travel distance, speed, acceleration time, decelera-
tion time, and relative/absolute can be set per point)
288 pulse/rotation(Accuracy: Within - 5 degrees at 20 ℃ at no load)
function via Setting of parameter, monitoring of control condition and the like
are enabled with RS485 interface. Max 31 units.
Setting of parameter and monitoring of control condition are ena-
bled with commercial PC. (When connecting a commercially avail-
able PC, an optional connecting cable is necessary. If PC has no
RS232port, RS232-USB converter is required.)
Optional regenerative resistor is available.*6
Overload, Overcurrent, Overvoltage, Undervoltage , System error, Set-
ting change warning, Over-speed, Sensor error, Overheat, Position er-
ror, External forced trip, Position error counter overflow, RS485 commu-
nication error, Operation execution error, Digital keypad communication
trouble, user parameter error, and system parameter error
±10 %
0 - +50 ℃ (free from freezing)*5
Not greater than 1000 m
Not greater than 4.9 m/s
6 points
2 points (Open collector)
30 – 4000 r/min *4
Inverse time-lag overload protection
Protection level 115 (Torque reference)
Torque reference 150, 1 minute
10 m or less (with optional extension cable）*2
3 m or less*2
Self cooling
100 W or less:0.37, 200 W or more:1
№ SX-DCT00221 -2-
(10-60 Hz)
²
Panasonic Corporation