Panasonic MINAS-BL KP Series Reference Specifications page 9

5.3 Connector for motor connection (MOTOR)
MOLEX 5569-8A-1210 or equivalent
Terminal number
1
2
3
4
5
6
7
8
■High voltage is applied to motor wire and CS signal line; Use caution for avoiding
electric shock.
■ Use a motor extension cable (option) for extending motor wire.
■ No. 4 to 8 terminals of option cable are shielded. But the shield material is
not grounded.
Please do not ground the shield material in order to avoid malfunctions or
damages.
■ No. 4 to 8 terminals of option cable are not isolated from commercial power
source. Use care to avoid electric shock and grounding fault.
5.4 Connector for communications (SER)
MOLEX 85503－0001 or equivalent
Terminal number
1
2
3
4
5
6
7
8
■The pin numbers are shown in the figure at right.
■The connection cable(DV0P383**) for Digital key pad is needed to connect
with the Digital key pad. (sold separately)
■The connection cable(DV0P383**) for Digital key and PC cable (DV0P4140)
are needed to use RS232C communication control software「PANATERM for BL」.
Terminal name
U
V
W
5VS 5 V (not insulated from power supply)
CS1
CS2
CS3
GNDS GND (not insulated from power supply)
Terminal name
－
+5VL
SOT
Digital key pad communication
SIN
RS485+
RS485-
GNDL
Digital key pad communication
SCK
Description of terminal
Motor U phase
Motor V phase
Motor W phase
CS signal
CS signal
CS signal
Description of terminal
Do not connect anything.
power supply 5 V
or PANATERM for BL
Connect RS485+
Connect RS485-
Signal ground
№ SX-DCT00221 -6-
８ １
Panasonic Corporation