JDS Uniphase ORL-55 Series Operating Manual page 31

OFF Laser switched off.
External power supply
The ORL-55 is powered by the external AC
adapter when this symbol is shown.
Battery status
This indicates the battery charge status. If
it is not shown, only the AC adapter is
active.
USB Power supply via USB
The device is powered via the USB
interface for remote operation.
PERM Power mode
ECON • PERM: Device remains switched on.
• ECON: Device switches off 20 minutes
1310nm Wavelength
Display of selected wavelength.
1310nm
1550nm Possible combinations:
1  2  1 + 2)  1 ...
-3.00dBm Output power level
Displayed for each selected wavelength.
CW Signal Modulation
 CW: Continuous wave
Auto-
 Auto-: Auto wavelength detection
 270 Hz, 1 kHz, 2 kHz: modulation
Center of Power level
display
Display of power level.
JDSU
after the last operation.
frequency
ORL-55
5 O
PERATION
27