JDS Uniphase ORL-55 Series Operating Manual page 32

5 O
PERATION
SOURCE MAIN menu
 Press [MENU ENTER] to open the SOURCE MAIN
menu.
Select Auto- ON
(OFF)
Select Modulation Select modulation frequency
Level Adjust
Configuration
All following settings refer to the SOURCE MAIN menu.
Auto-Lambda
Switching Auto- on/off
 Press [MENU ENTER] to switch Auto- on and off
(toggle function).
Note: Signal is modulated only (with 270 Hz, 1 kHz,
2 kHz), when Auto- is deactivated.
28
Switch on/off Auto- (see next
section).
(see „Signal modulation" on
page 29).
Set output power level (see
„Adjusting the output power level"
on page 29)
Open configuration menu for
basic settings (see
measurement mode" on
page 18).
ORL-55
„Selecting
JDSU