Sales Demo Mode (Showroom) - Bosch SHP65TL5UC Repair Instructions

3.7

Sales demo mode (showroom)

3.7.1 Preparing dishwashers
Do NOT disconnect drain pumps when using sales demo
programs. Dishwasher controls run safety checks – if drain or
heat pumps are disconnected, dishwashers will NOT run.
No disconnections are needed – just add one (1) gallon of water
(with bacteria stat) to dishwasher tanks. Heat pumps will run and
lights will light when program buttons are pressed. Drain pumps
do not run. It's not necessary to plug drain hoses, but it's a good
practice to prevent any possible water leakage.
3.7.2 Entering the sales demo mode program
• If the dishwasher needs to be reset, turn it on and off
again. The dishwasher must be off to enter the program.
• While pressing and holding both the "B" and "C" buttons
(below), press and hold the On / Off button (to turn the
dishwasher on) until the display shows "P0". Release all
buttons.
• To enter the sales demo mode program, press the "B"
button repeatedly until the display shows "P7".
702_58300000170749_ara_en_c This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary
information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
3.7.3 Running the sales demo mode program
• Press the "C" button (below) to start the customer service
test program. The display will show "1:23".
• To run the sales demo mode program:
o For front button models – open and close the door.
o For top button models – close, then open, then
close the door (i.e. close the door twice and open it
once).
3.7.4 Exiting the sales demo mode program
• For top button models (only), open the door.
• Reset the sales demo program by pressing and holding
the Start button for three (3) seconds. The display will
show "0:01".
• Turn the dishwasher off to exit the program.
Page 15 of 82