Sales Demo (Showroom) Program - Bosch Ascenta SHX3AM Repair Instruction

• To scroll through programs, press "<" button.
• To start programs shown with "*", press ">" button.
• To exit special programs, turn dishwasher off.
• Programs shown with "+" are started with the Start button
(don't run these programs).
• Run only programs shown in bold type (fault codes,
customer service & sales demo).
3.6

Sales demo (showroom) program

3.6.1 General instructions
Unlike with traditional dishwashers, do NOT disconnect drain
pumps when using sales demo programs. Dishwasher controls
run safety checks – if drain pumps or heat pumps are
disconnected, dishwashers will NOT run.
No disconnections are needed – just add one (1) gallon of water
(with bacteria stat) to dishwasher tanks. Heat pumps will run and
lights will light when program buttons are pushed. Drain pumps
do not run. It's not necessary to plug drain hoses, but it's a good
practice to prevent any possible water leakage.
3.6.2 SHE4AM/5AM "Evolution" models
• Entering special programs – Press and hold ">" and Delay
buttons, then turn dishwasher on. Left program light will flash
nd
and 2 program light from left will be lit. (on SHE5AM models,
digital display will show "P0").
• Selecting sales demo program - Press "<" button to scroll to
customer service test program. Left three program lights will
be lit (on SHE5AM models, digital display will show "P7").
• Using sale demo program - Press ">" button to start program.
Active and Regular Wash lights will always be lit (on
702_58300000130262_ara_en_b
SHE5AM models, digital display will always show "1:23").
Pressing buttons will light corresponding light.
• Exiting sales demo program - Press and hold ">"and Delay
buttons, then turn dishwasher off to exit program. Pressing
on/off button during sales demo program shows how
dishwasher resets, but does not reset dishwasher, turn
dishwasher off or exit sales demo program.
SHE4AM/5AM Sales demo pgm*
3.6.3 SHX3AM "Integra" models
• Entering special programs – Press and hold "<" and
">"buttons, then turn dishwasher on. Regular Wash light will
flash and Quick Wash light will be lit.
• Selecting sales demo program - Press "<" button to scroll to
customer service test program. All three program lights will be
lit.
• Using sale demo program - Press ">" button to start program.
Active and Regular Wash lights will always be lit. Pressing
buttons will light corresponding light.
•
Exiting sales demo program
buttons, then turn dishwasher off to exit program. Pressing
on/off button during sales demo program shows how
dishwasher resets, but does not reset dishwasher, turn
dishwasher off or exit sales demo program.
SHX3AM Sales demo program *
SHE4AM/5AM SHE5AM
program lights digital display
P7
- Press and hold "<" and ">"
SHX3AM program lights
Power
Scrub Regular Quick
Page 8 of 27