Bosch SHP65TL5UC Repair Instructions page 40

Hide thumbs Also See for SHP65TL5UC:
Table of Contents

Advertisement

5.1.4.4 To reinstall base cover
1. To reinstall base cover, insert slots onto base.
2. Tilt top of base cover toward base and fasten with two (2)
screws.
5.1.4.5 To remove overflow trough (channel)
Tools needed: #2 Phillips & small flat blade screwdrivers.
1. Remove base cover – section 5.1.4.3.
2. Pry off clips at each end of channel (below).
3. Carefully pry support from tab on channel and lift support
out and away from dishwasher (below).
702_58300000170749_ara_en_c
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary
information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
5.1.4.6 To remove inner door
Inner doors rarely need to be removed for repairs, but need to be
removed to access the lower door seal and door hinge lever.
Tools needed: T20 Torx & #2 Phillips screwdrivers, pliers &
gloves.
1. Remove outer door – section 5.1.2.1.
2. Disconnect & pull out dishwasher – section 5.1.5.1.
Pull dishwasher out enough to clear hinges.
3. Remove fascia panel – section 5.1.2.2. This eliminates
disconnecting and reconnecting all wire harnesses.
4. If replacing inner door, remove dispenser – section 5.3.1.
5. If the lower door seal sticks to the inner door, separate the
seal from the door by hand (below left).
6. Disconnect door springs from hinge levers (below center).
For easier removal, pull the cord over the bottom pulley
first to release spring tension.
7. Remove two (2) hinge screws on both sides of inner door
(below right). The bottom screws also hold the lower door
seal.
CAUTION: Inner door edges (at the hinge) are sharp! Use
gloves, cover door edges and remove inner door carefully.
Page 40 of 82

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents