Bosch SHP65TL5UC Repair Instructions page 13

3.5.2 End of Cycle Tones (SHX / SHV models)
Press the On / Off button to turn the dishwasher on.
pressing and holding the "A" button (below), press and hold the
Start button until the display shows "d:00". Release both buttons.
Press the "A" button (above) until the display shows "b:02".
Press the "C" button (above) repeatedly to make the tone louder
or softer ("b:00" = Off and "b:03" = loudest). Press the Start
button to save the setting.
3.5.3 Child Lock (selected models)
3.5.3.1 To activate the child lock:
Press the On / Off button to turn the dishwasher on. Press any
wash cycle, then press the Start button to start the cycle. Press
and hold down the button with "Child Lock" printed underneath it
for approximately four (4) seconds until the display reads "CL".
As long as the display shows "CL", the wash cycle won't be
changed or reset if any button is pressed.
3.5.3.2 To deactivate the child lock:
Press and hold the "Child Lock" button for around 4 seconds until
the display no longer reads "CL".
702_58300000170749_ara_en_c
While
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary
information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
3.5.4 Changing rinse-aid settings (selected models)
The amount of rinse aid dispensed can be set from "r:00" (off) to
"r:06" (max.).
Press the On / Off button to turn the dishwasher on.
pressing and holding the "A" button (below), press and hold the
Start button until the display shows "d:00". Release both buttons.
Press the "A" button (above) until the display shows "r:05". Press
the "C" button (above) repeatedly to scroll through the settings
below:
• "r:00" = dispenser is Off
• "r:01" = lowest setting
• "r:02" = low setting
• "r:03" = medium setting
• "r:04" = medium-high setting
• "r:05" = high setting
• "r:06" = highest setting
Press the Start button to save the setting.
3.5.5 Displays affected by "0" rinse-aid settings
If the rinse-aid setting on the control is set at "r:00" ("none"),
dishwashers will raise drying temperatures and lengthen wash
cycles to compensate for not using rinse-aid. When customers
complain about longer cycle times, check the rinse-aid setting on
the control – if it is "r:00", change it to a desired setting.
While
Page 13 of 82