Table of Contents
Advertisement
Knife height adjustment
When adjusting the clearance angle, the knife edge should be positioned as exactly as possible in the
actual center of rotation of the knife holder. The lay-on edge
serves as a reference position for correct knife height adjustment. The knife edge should be parallel
with the locating edges.
• Rotate the knurled nuts
lay-on edge
(→ Fig. 30-6)
• To clamp the knife
(rotate clockwise).
Lateral repositioning of the knife
• Push knife guard
• Loosen the clamping screws
• Push the knife
• To clamp the knife
located on the side to which the knife has been repositioned by turning it clockwise.
1
Fig. 31
(→ Fig. 31)
5.9.8 Knife holder E/E-TC
Note
The knife holder E-TC is designed for the Leica TC-65 tungsten carbide blades.
Warning
Prior to inserting the blade, both knife holder and knife holder base must have been installed on the
instrument!
Leica RM2125 RTS
(→ Fig. 30-3)
uniformly and backwards until the knife blade is parallel to the
of the rear clamping chucks.
(→ Fig. 30-5)
evenly screw the two knife clamping screws
(→ Fig. 30-1)
to the center.
(→ Fig. 30-4)
(→ Fig. 30-5)
to the left or right as required.
(→ Fig.
30-5), always tighten the clamping screw
Knife holder NZ
For holding conventional and carbide metal knives up to 16 cm in length.
Knife pressure plate
(→ Fig. 31-1)
blade.
(→ Fig. 30-6)
by turning them counterclockwise.
for extreme stability and full utilization of the knife
Operation
of the rear clamping chucks
(→ Fig. 30-4)
(→ Fig. 30-4)
first which is
5
inward
41
Advertisement
Table of Contents
