5
Operation
5.3
Adjusting the clearance angle
2
1
Fig. 14
(→ Fig. 14-1)
• The index marks (0°, 5° and 10°) for adjustment of the clearance angle
the right side of the knife holder
• There is also an index mark
which serves as a reference point when adjusting the clearance angle.
• When using the knife holder base (non-orientable), loosen the Allen screw to release the clamp by
turning Allen key No. 4
• When using the knife holder base (with lateral movement), rotate the lever on the right side of the
knife holder base counterclockwise.
• Move the knife holder until the index mark of the desired clearance angle coincides with the
reference line on the knife holder base.
Example:
Enlarged detail showing a clearance angle setting of 5°.
26
3
5
6
Enlarged detail: Index marks for clearance angle adjustment
(→ Fig.
(→ Fig. 14-6)
(→ Fig. 14-3)
counterclockwise.
4
14-4).
on the right side of the knife holder base
(→ Fig. 14-5)
are located on
(→ Fig. 14-2)
Version 2.6, Revision J