CHAPTER 2 Setting up the Phone
Action
5
6
7
If the LAN to which the phone is connected supports Power over Ethernet (PoE), no AC
adapter is required; the phone receives power from the Ethernet network.
Prior to connecting power, refer to the Compliancy and Regulatory Information at
www.audiocodes.com/library.
Mounting the Phone
The phone can be mounted on a:
■
Desk (see Desktop Mounting below )
■
Wall (see Wall Mounting on the next page )
See also
https://www.youtube.com/watch?v=oGe9STB9lFE
Desktop Mounting
The documentation following shows how to mount the phone on a flat surface like a desk.
➢ To mount the phone on a flat surface like a desk:
1.
Off-hook the handset (if on-hook) and place the phone upside down, i.e., base-up, on
your desktop.
2.
On the phone's stand, identify outer notches.
3.
On the phone's base, identify outer rails.
4.
Invert the stand and align its outer notches with the base's outer rails.
5.
Insert the stand's outer notches into the base's outer rails and slide the notches along the
rails until the stand click-locks into the base.
6.
Revert the phone and stand it on the desktop.
Connect the RJ-45 PC port to a computer/laptop, using a CAT 5 / 5e straight-
through Ethernet cable
Connect the phone's RJ-45 LAN port to your LAN network (LAN port or LAN
switch/router) using a CAT 5 / 5e Ethernet cable.
Internal use only. FAEs use the port to debug and troubleshoot the phone - after
connecting the AUX (auxiliary) port to a terminal monitor with a serial cable.
C448HD and C450HD | Users & Administrator's Manual
Description
to assemble the base stand.
- 11 -