Mounting The Phone; Placing The Phone On A Desk; Adjusting Phone In Vertical Plane; Routing The Phone's Cables - AudioCodes 300HD Series User Manual

2.4

Mounting the Phone

The phone can be mounted in one of the following ways:

Desktop mounting (see Section

Wall mounting (see Section
2.4.1

Placing the Phone on a Desk

This section describes the procedures for placing the phone on a desk or flat surface. This
includes adjusting the angle of the phone (see Section
cables (see Section
2.4.1.1

Adjusting Phone in Vertical Plane

You can adjust the angle of the phone in the vertical plane, using the phone's bracket.

To adjust the tilt of the phone:
1. Press tab (A) to loosen the bracket lock.
2. As you press the tab, move (B) up or down a slot to adjust tilt.
3. Release tab (A) to lock the bracket to a desired slot.
2.4.1.2

Routing the Phone's Cables

The phone provides grooves for routing the LAN, PC, and AC power cables to ensure
uninterrupted connections.

To route the phone's LAN and PC cables:
1. Plug the PC cable in the PC port.
2. Insert the PC cable in the allotted slot on the left side of the bracket.
User's Manual
2.4.1
2.4.2 on page 18)
2.4.1.2 on page 16).

Figure 2-4: Adjusting the Phone in Vertical Plane

below)
2.4.1.1
16
320HD IP Phone
below) and routing the phone's
Document #: LTRT-24503