Ip Address - Agilent Technologies PSA Series User Manual

4.1.1 IP Address

Sets the IP Address of the external source to be controlled by the PSA.
Mode:
Key Path:
Remote Command:
Unit/Terminator Keys:
Factory Preset:
State Saved:
Range:
Dependencies and
Couplings:
Factory Preset
State Saved
Example:
Chapter 4
Spectrum Analysis
Source, Ext Src Config, 1 | Source, Ext Src Config, Show Setup
:SYSTem:COMMunicate:LAN:SOURce[:EXTernal]:IP
<string>
:SYSTem:COMMunicate:LAN:SOURce[:EXTernal]:IP?
Enter
0.0.0.0
Saved in instrument state.
Numeric and the '.' character. String must be of the form
<integer>.<integer>.<integer>.<integer>
Establishes a connection with the entered IP Address at port
5025. If a connection can not be established at any time
(perhaps if the entered IP address is incorrect, or if the external
source or PSA are disconnected from the LAN) then the IP
address is reset to '0.0.0.0'.
If you are using a cross-over LAN cable to connect the
instruments directly together, then the IP addresses of both the
instruments must start with the same two integers. That is, if
the spectrum analyzer IP address is 156.121.12.122, the source
IP address must be 156.121.xxx.xxx.
Once a valid connection has been confirmed, if the external
source or PSA is disconnected from the LAN the connection will
not be identified as invalid until you change a parameter that
requires the external source to be reconfigured.
The following operations are disabled if a LAN connection is not
established with your specified IP Address:
• External Source Amplitude
• External Source Amplitude Step
• Configure Sweep functions
• Normalize
• Open/Short CAL
Persistent setting survives instrument preset and power cycle.
No
SYST:COMM:LAN:SOUR:IP 123.109.355.12
Source Key and Programming Commands
External Source Configuration
47