Agilent Technologies PSA Series User Manual page 23

3. Press the
the PSA Series analyzer into Spectrum Analysis mode.
4. Press the Source key to display the
5. Press the
IP address of an external signal source. If this IP address does not
match the IP address of your ESG-C or PSA signal source (from
Step 2 above), then you need to change it using Steps 6 and 7.
6. Press the
7. Enter the IP Address of the ESG-C or PSG signal source using the
numeric keypad, and press the
If you are using a cross-over LAN cable to connect the instruments
NOTE
directly together, then the IP addresses of both the instruments must
start with the same two integers. That is, if the spectrum analyzer IP
address is 156.121.12.122, the source IP address must be
156.121.xxx.xxx.
Chapter 1
Setting Up Your Signal Analyzer and Signal Source
key followed by the
MODE
softkey to display the current value for the
Ext Src Config
softkey so that the key label is highlighted.
IP Address
Enter
Getting Started
softkey to put
Spectrum Analysis
menu.
Ext Source
key.
23