Keysight Technologies X Series Measurement Manual page 49

Saving Data
Overview
Export Data Menu Details
Keysight N6141A Measurement Guide
Amplitude
Correction A Corrections Data File contains a copy of one of the
receiver correction tables. Corrections provide a way to
adjust the trace display for predetermined gain curves.
There are 6 Corrections available for the Mode. Once a
correction is selected, the key returns back to the
Export Data menu and the selected Correction number
is annotated on the key. See
page
Trace The trace file contains "meta" data which describes the
current setting of the receiver, but it is not the full state
of the receiver.
You can select Traces 1, 2 3, or All. You cannot recall a
trace file that was saved with "All" selected. See the
following:
"Frequency Scan Trace Data File" on page
"Strip Chart Trace Data File" on page 53
"Monitor Spectrum (IF Mode) Trace Data File" on
page 54
Limit Limits may be exported into a data file with a .csv
extension. They may be imported from that data file;
they may also be imported from a legacy limit file with a
.lim extension. The .lim files meet the specification for
limit files contained in the EMI measurement guide, HP
E7415A. See
Signal List A Signal List file contains a copy of one of the signal
lists obtained during measurement. See
Data Files" on page
Scan Table A Scan Table file contains a copy of one of the files
obtained during a measurement.
Meas Results In the Frequency Scan measurement, the Meas Result
file is in the format of .html or .pdf. It is a report that
contains the measurement result. You can configure the
content using either the setup form or softkeys. Using a
mouse and keyboard may make filling out the form
easier, but you can also accomplish the task through
the front panel keys. The checkboxes or radio buttons
on the setup form are tied to the corresponded softkeys
as you select them. See
page
51.
"Limit Data Files" on page
58.
"Meas Results Data Files" on
59.
"Correction Data File" on
52.
56.
"Signal List
49