Keysight Technologies X Series Measurement Manual page 32

Disturbance Analyzer (Click) Measurements
Making a Measurement
Step
4. Access the Setup
Table to configure a
Click measurement
NOTE The MXE allows you to either make measurements using autocoupled settings or manual
settings. When using autocoupled settings, the limits and input attenuation settings used
during the measurement are determined by your measurement frequency and terminal
selection. These autocoupled settings provide the appropriate limit values as given in
CISPR 14.
32
Action
Setup Table
a. Press
Notes
From this display you
can:
—View the status
of a data collection
in progress.
—Access the
navigation and
editing features of
the disturbance
list.
—Access the
measurement
setup table
This table enables you to configure the
measurement with all of the parameters
needed to measure Clicks to the appropriate
limit.
Keysight N6141A Measurement Guide