Pannoramic 250 FLASH III 3.0.2 User's Guide
7.4.2 Replacing fuses of the main power switch
1. Switch off the main power supply and disconnect the power cable (see chapter 1.1.4 Main
parts of the Base Unit).
2. The fuse compartment is located next to the main power supply switch at the back side of
the Pannoramic® 250 FLASH III.
3. Release lock (1) by pushing the lever to the left, so the insert (2) can be pulled out.
4. Remove insert from the compartment.
5. Replace fuses, put the insert back into its mounting, and push it inwards until you hear a
snap, so the lever locks.
September 16, 2020 – Rev. 1
Figure 101 – Location of the fuse compartment
Figure 102 – Removing the fuse insert
Figure 103 – Replacing the fuses
3DHISTECH Ltd.
7 Troubleshooting and Maintenance
143(156)