Pannoramic 250 FLASH III 3.0.2 User's Guide
3.3.3 Opening/Closing the FL protective cover
Open the protective cover by moving it upwards and lay it down to the upper cover of the unit, then
insert magazines.
When scanning slides, close the FL protective cover (1) of the base unit after inserting the
magazine(s) into the input stack.
1. Mount the protective cover properly.
2. After finishing the digitization process, open the protective cover.
3. Remove the magazine(s) from the output stack and put the magazine cover on them.
September 16, 2020 – Rev. 1
Figure 17 – Opening the FL protective cover
3DHISTECH Ltd.
3.3.3 Opening/Closing the FL protective cover
37(156)