Pannoramic 250 FLASH III 3.0.2 User's Guide
3.3 Inserting and Removing Slides
3.3.1 Insert slides into a magazine
Only original 3DHISTECH P250 magazines are allowed for use with
Pannoramic® 250 FLASH III!
The magazines can contain a maximum of 25 slides.
Push slide (1) into the magazine (3) with its barcode end (2) first. The symbols on the side of
•
the magazine demonstrate the proper way of inserting slides.
The magazine and its proper insertion is identified by a sensor in the main unit upon
•
actuating it by the magnet in the side of the magazine (4).
You should insert several slides into a magazine without empty slots.
Begin the insertion on position 1 of the magazine.
To insert or remove a filled magazine from the device, slightly tilt it to
its closed side to prevent the slides from accidentally falling out.
September 16, 2020 – Rev. 1
Figure 13 – Inserting slides into a magazine
Caution!
Note:
Caution!
3DHISTECH Ltd.
3.3 Inserting and Removing Slides
33(156)