Battery - Meec tools Multi Series Operating Instructions Manual

BATTERY

NOTE:
• Make sure the power switch is not pressed in when inserting or replacing the battery.
• Do not force the battery when connecting it, use a moderate pressure. An incorrectly connected
battery can damage the battery terminals or the battery socket on the circular saw.
• Use the "Press" button (diagram 1) on the battery to check the charging status; 1-4 red LEDs,
where 1 indicates low battery status.
1
Charging the battery
NOTE:
• The battery must be charged before the circular saw can be used.
• After charging for the first time, use the circular saw until the battery is completely discharged.
Repeat this charging and discharging cycle 4 to 5 times.
• If the LEDs on the charger do not go on when charging:
– check that the charger's mains adapter is properly plugged into the power point and that
the charger is switched on
– check that the battery is correctly inserted in the charger
1. Place the battery charger on a level and stable surface. Plug the charger into a 230 V
power point.
2. Connect the battery to the charger so that it clicks into place (diagram 2). The red LED lights
up on the charger when correct contact is made.
3. When the battery is fully charged, after about one hour, the red LED goes off and only the
green LED stays on.
4. Unplug the charger from the power point and remove the battery from the charger.
2
EN
61