Gerber EDGE Owner's Manual page 48

42 GERBER EDGE Owner's Guide
Changing the EDGE overlap setting
Changing the
the desired overlap, and pressing the RESET key (RS) to return to the Offline
mode
To change the EDGE overlap setting
1. Plug in and turn on the
2. The
3. Repeatedly press the SETUP key until the display reads
by the number of pixels. (The factory default is 15.)
Note: There are additional selections in the Setup menu that are used for
Gerber diagnostic purposes only. If you go beyond the menu selection you want,
repeatedly press the SETUP key until that selection appears again in the
display. Do not change any settings except for checksum, test pattern, or
overlap without first consulting the Gerber Field Service Department.
4. Press the left or right VINYL SLEW key to increase or decrease the amount
of overlap.
5. Press the RESET key. The display reads
overlap setting consists of opening the Setup menu, setting
EDGE
first, then the computer.
EDGE
display reads OFFLINE
EDGE
.
OVERLAP
OFFLINE .
followed