Gerber EDGE Owner's Manual page 45

Resetting to factory parameters
The
EDGE
or if an incorrect checksum alters the settings, the
properly. If you suspect a problem, reset the
your job again. If you still have a problem, contact the Gerber Field Service
Department.
To reset the EDGE factory parameters
1. Turn off the
2. Press and hold the RESET key.
3. Turn on the
OFFLINE
4. Release the RESET key. The
Setup menu
When you press the SETUP (SU) key from the Offline mode, the
the Setup menu. The Setup menu allows you to change the print test pattern, the
checksum, or the amount of overlap when restarting a job after a pause.
EDGE
To change the print test pattern, repeatedly press the Setup key until the keypad
display reads
VINYL SLEW key to step through the test pattern choices, then press the
RESET (RS) key to return to the Offline mode.
Note: There are additional selections in the Setup menu that are used for
Gerber diagnostic purposes only. If you go beyond the menu selection you want,
repeatedly press the SETUP key until that selection appears again in the
display. Do not change any settings except for checksum, test pattern, or
overlap without first consulting the Gerber Field Service Department.
There are special reasons for using the SETUP key regarding the checksum
setting:
The checksum setting of the
of the Gerber software release.
The checksum setting of the
embedded in the spool file being printed.
is set to certain parameters at the factory. If you change these settings,
.
EDGE
and keep the RESET key pressed until the display reads
EDGE
.
EDGE
TEST PATTERN
followed by the test pattern number. Press either
EDGE
EDGE
Mechanical Description
may not operate
EDGE
to factory parameters and try
EDGE
is reset to factory parameters.
must be the same as the checksum setting
must be the same as the checksum setting
39
enters
EDGE