Gerber EDGE Owner's Manual page 17

3. Clean both sides of the foil squeegee using a pad
moistened with isopropyl alcohol. Allow to air dry.
4. Remove and discard the foam core locks from the
color cartridge.
5. Hold the color cartridge vertically with the label
facing toward the inside of the cover. Orient the
cartridge so that the glossy side of the foil faces
toward the right as shown in the illustration.
6. Insert the color cartridge
toward the rear of the cover
until it touches, then rides up
on, the ramp.
7. Rotate the cartridge to the right
until it covers the cartridge pin
plate and the left side of the
cartridge is behind the curve of
the support bracket.
8. Release the three cartridge pins
under the cartridge pin plate so
that they secure the color
cartridge in the head support.
9. Press the FOIL SLEW key
until the cartridge pins snap
into place and the foil moves.
10. Close the cover.
To print the job
Note: There may be a pause after you press ONLINE before the printing starts.
1. Press ONLINE on the keypad.
2. The may go through a brief warm-up cycle. If so, the
EDGE
reads:
WARMING UP
Getting Started 11
display
EDGE